Knitted Little Axe

The knitted little axe is not just a cute accessory but also a handy tool for crafting and creating beautiful projects. Its small size makes it perfect for detailed work and intricate designs. The soft, knitted material provides a comfortable grip while handling the axe, making it ideal for long crafting sessions. It adds a touch of whimsy to any crafting setup and is sure to become a favorite among crafters. Whether you're a seasoned knitter or just starting out, the knitted little axe is a delightful addition to your crafting tools, bringing a fun and playful element to your projects.

Materials
-3mm needles
-Light silver/grey DK yarn
-Dark silver/grey DK yarn
-Brown DK yarn
-Tapestry/yarn needle for seaming

Abbreviations
CO = Cast on
St(s) = Stitch(es)
St-st = Stocking Stitch – K 1 row, P 1 row
G-st: = Garter stitch – K every row
K# = knit # stitches
P# = purl # stitches
K2tog = Knit 2 stitches together
P2tog = Purl 2 stitches together
Inc = Increase by your preferred method (I prefer to M1)
Dec = Decrease by knitting (purling) 2 stitches together (if you’re on a K (P) row)
BO = Bind off
Three needle BO = Pick up CO sts whilst BO to create a neat edge seam

Finished size: Approx 13cm

Axe Head (make 1)
Start at the bit (sharp edge) then decrease for the beard, before knitting a length that forms the butt. Increase again for the other side of the beard and then finish on the bit again. Three needle BO the start and end to join the axe head together. Additional sewing will be required at the end around the other edges of the axe.

CO12 sts in In light silver/grey:
1 – 2 – Starting with a K row, work 2 rows st-st.
Change to dark silver/grey
3 – 4 – st-st 2 rows
5 – BO 4 sts, K2tog, K to end (7sts)
6 – P1, P2tog, P to last 2 sts, P2tog (5sts)
7 – 18 – St-st 12 rows
19 – K1, inc 1, K to last 2 sts, inc 1, K1. (7sts)
20 – P to last st, inc 1, CO 4 sts (12)
21 – 22 – st-st 2 rows
Change to light silver/grey
23 – 24 – st-st 2 rows
Three needle BO

Handle
Knit length of handle, fold in half edgeways to create a firm tube and stitch closed.

CO 30 sts in brown (less if you want a smaller shaft).
1 – 3 – In G-st, K 3 rows
BO

Assembly
Slide handle into axe head opening until enough of the handle is visible at the top to your liking (or use photo as a guide). Sew edges of axe head closed and firmly fix the handle in place.